Why is my novolog cloudy

The amount of time can be affected by exercise, diet, illness, some medicines, stress, the dose, how you take it, or where you inject it. Insulin strength is usually U or units of insulin in one millilitre of fluid. Short-acting regular insulin is also available in U This is five times more concentrated than U regular insulin.

Long-acting insulin glargine is also available in U This is three times more concentrated than U long-acting insulin. Be sure to check the concentration of your insulin so you take the right amount. Insulin is made by different companies.

Make sure you use the same type of insulin consistently. Rapid-acting insulins work over a narrow, more predictable range of time. Because they work quickly, they are used most often at the start of a meal. Rapid-acting insulin acts most like insulin that is produced by the human pancreas. It quickly drops the blood sugar level and works for a short time. If a rapid-acting insulin is used instead of a short-acting insulin at the start of dinner, it may prevent severe drops in blood sugar level in the middle of the night.

Short-acting insulins take effect and wear off more quickly than long-acting insulins. A short-acting insulin is often used 30—60 minutes before a meal so that it has time to work. These liquid insulins are clear and do not settle out when the bottle vial sits for a while.

Intermediate- and long-acting insulins contain added substances buffers that make them work over a long time and that may make them look cloudy. When these types of insulin sit for even a few minutes, the buffered insulin settles to the bottom of the vial. Forums New posts Search forums. Media New media New comments Search media. Members Current visitors New profile posts Search profile posts.

Log in Register. Search titles only. Search Advanced search…. New posts. Search forums. Log in. Install the app. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. You are using an out of date browser. Remove the inner needle cap and throw it away.

Hold the pen with the needle straight up. Tap the side of the pen to get rid of any air bubbles. Push the injection button until you see 0 in the dose window. You should see a drop or stream of liquid at the end of the needle. This means your pen is ready to use. Repeat steps 7 and 8 one or two more times if you need to, until you see a drop of insulin.

Check the dose window to make sure it shows 0. Turn the knob on the end of the pen to find your dose. The pen will make a click for each unit of insulin. The largest dose the pen will allow is 80 units. If your dose is larger than this, you will need to do more than one injection. Use your thumb to slowly press the button on the end of the pen all the way in.

Hold it for 10 seconds to allow time for the insulin to get into your body. Put the outer needle cap on the end of the pen and unscrew the needle. Novolog: If the pen will not let you dial up your dose, it does not have enough insulin left. Novolog Mix: Throw the pen away when there are less than 12 units of insulin left. You need at least 12 units to mix the insulin properly.

For informational purposes only.